3004-H32 aluminum is 3004 aluminum in the H32 temper. To achieve this temper, the metal is strain hardened, and then stabilized, to a strength that is roughly a quarter of the way between annealed (O) and full-hard (H38). It has the second highest ductility compared to the other variants of 3004 aluminum. The graph bars on the material properties cards below compare 3004-H32 aluminum to: 3000-series alloys (top), all aluminum alloys (middle), and the entire database (bottom). A full bar means this is the highest value in the relevant set. A half-full bar means it’s 50% of the highest, and so on.
the 5052 aluminum alloy is used to make beverage closure without internal pressure. The raw material is 5052 H19 aluminum sheet, the material is first oxidized to improve the coating adhesion and corrosion resistance. After the two sides are painted, the can lid is formed. So 5052 aluminum is another material for processing closures. 5052 aluminum sheet has good oxidation coloring effect, excellent metal texture and hardness, wear resistance and corrosion resistance, long service life, and is widely used in high-end mobile phone casings, high-end air-conditioning casings and other fields with high requirements for oxidation and metal texture.
3003 Aluminum Alloy contains Manganese as its major alloying element. 3003 Aluminum is an alloy with very good corrosion resistance and moderate strength. It is not heat treatable and develops strengthening from cold working only. 3003 Aluminum Alloy has good machinability and welding is readily accomplished by means of conventional welding methods. Commonly used in chemical equipment, ductwork, and in general sheet metal work. 3003 Aluminum is typically used in stampings and the manufacturing of pressure vessels, builder’s hardware, garage doors, awning slats, refrigerator panels, gas lines, gasoline tanks, heat exchangers, drawn and spun parts, and storage tanks. All of our 3003 Aluminum Sheet is protected on one side with a protective vinyl film.